StudentShare
Contact Us
Sign In / Sign Up for FREE
Search
Go to advanced search...

Energy in food lab practical - Coursework Example

Cite this document
Summary
Mushrooms were found to have a higher average energy content of 1418± 764KJ/g, followed by oil at 800± 357 KJ/g and finally bread with 454±350KJ/g. The high energy content of mushrooms is…
Download full paper File format: .doc, available for editing
GRAB THE BEST PAPER97.1% of users find it useful
Energy in food lab practical
Read Text Preview

Extract of sample "Energy in food lab practical"

Download file to see previous pages

However, the results are valid for the determination of the energy content of foods. The energy intake in human beings is dependent on the diet. There is increasing evidence that the dietary energy density is an important characteristic in estimating energy intake. The challenge however lies in the development of methods to derive energy density (Cox and Mela 49). Therefore, the determination of energy density of most diets can be deemed as a multifaceted if not involved process. In connection to this, there are factors that limit the accuracy of the procedure and its totality in estimating the energy density of a given diet.

Three methods have been previously documented and compared in the determination of Energy density. The first is all foods and beverages, the second considers only food and caloric beverages and the third is biased towards food only. It is evident from a consideration of each method that there will be significant differences in the energy density obtained. . Fats carbohydrates and proteins are the chief sources of energy in the human diet. Fats and carbohydrates contain hydrogen, carbon and oxygen whereas proteins in addition to these contain nitrogen.

The heat released through the oxidation of food is the heat of combustion, and it is widely accepted to be synonymous with its gross energy value. The primary objective of this research was to determine the energy density of bread, mushroom, and oil Bread, oil, mushrooms, distilled water, clamp, boiling tube and burner. Also, thermometer, Heatproof mat, Measuring cylinder, 50 cm3 or 100 cm3 and Mounted needle with wooden handle. In addition, Tongs or forceps for food samples that cannot be impaled Thermometer (–10 °C to 110 °C) and Eye protection were also used.

The food samples of mushrooms and bread were dried before being cut into 1 cm2 or 0.5 cm3. The boiling tube was held in position using a clamp stand and 20ml of water transferred into it. The water temperature was measured

...Download file to see next pages Read More
Cite this document
  • APA
  • MLA
  • CHICAGO
(“Energy in food lab practical Coursework Example | Topics and Well Written Essays - 1000 words”, n.d.)
Retrieved from https://studentshare.org/biology/1672733-energy-in-food-lab-practical
(Energy in Food Lab Practical Coursework Example | Topics and Well Written Essays - 1000 Words)
https://studentshare.org/biology/1672733-energy-in-food-lab-practical.
“Energy in Food Lab Practical Coursework Example | Topics and Well Written Essays - 1000 Words”, n.d. https://studentshare.org/biology/1672733-energy-in-food-lab-practical.
  • Cited: 0 times

CHECK THESE SAMPLES OF Energy in food lab practical

Design and Analysis of the New Engine Cover for Race Car

The lab work was carried out using the Computational Fluid Dynamics.... The lab investigated the engine cover shape to decrease the complex airflow and drag for the car back… Augmenting the engine cover was incorporated to regulate the complex flow due to vortices and turbulence.... The lab was also effective in perfoming Computational Fluid Dynamics simulation on the helmet....
10 Pages (2500 words) Lab Report

Synthesis and Characterization of the Polyhalogen Complex CsICl2

As a means of facilitating comprehension of polyhalogens complexes, practical experiments involving synthesis and characterization of these compounds… This lab report covers on the laboratory preparation of Cs [ICl2]; a polyhalogen complex containing cesium as the central atom, and iodine and two chlorine ions as the attached halogens.... As a means of facilitating comprehension of polyhalogens complexes, practical experiments involving synthesis and characterization of these compounds are performed....
2 Pages (500 words) Lab Report

Tensile testing

The modulus of elasticity determines the amount of energy in a material.... The test consists of loading a specimen of known dimensions in tension, with the loading force being gradually School of Maritime and Mechanical Engineering Faculty of Engineering and Technology lab 7 – Tensile Testing Aim The aim of this laboratory is to gain a greater understanding of tensile testing procedures and to undertake a series of tensile tests on a range of materials....
2 Pages (500 words) Lab Report

The Analysis of the Mitosis and Meiosis

They have the same phases of division, but these processes and their results are significantly different1.... During mitotic cell division, each chromosome is divided into two identical chromosomes, which are distributed… During this division in mitosis, the hereditary factors do not change....
7 Pages (1750 words) Lab Report

The Building of an Electronic Dice

The paper "The Building of an Electronic Dice" highlights that the integrated circuit is very responsive to fixed electricity and therefore can be broken.... To avoid this problem of circuit breaking, these should be soldered in the appropriate positions as shown in the circuit board.... hellip; Next is the fixation of the electrolytic capacitor....
12 Pages (3000 words) Lab Report

A Kinematic Analysis of a Dominant Versus a Non-Dominant Leg Football Kick

he qualitative data was gained from the previous lab sessions.... In order to know the number of cameras that need to see one marker at any one time to reconstruct that markers in a 3D position, the cameras in the lab in the general locations for capture should be positioned....
8 Pages (2000 words) Lab Report

Speed Control of a DC and AC Motor Machine

The author of the "Speed Control of a DC and AC Motor Machine" paper examines speed control of separately excited DC motor by armature voltage variation, operation of a single-phase half controlled bridge rectifier, and waveform of the motor armature voltage operation.... hellip; The components that make up the DC motor including the stator and rotor winding which are separately excited, in this case, have independent DC voltage sources....
11 Pages (2750 words) Lab Report

The Use of Tuned Amplifier

From the paper "The Use of Tuned Amplifier" it is clear that the high frequencies input signals to be amplified are fed to the amplifier's input.... The parallel tuned circuit's resonant frequency is adjusted until it is equal to the input signal's frequency by changing the values of capacitances....
5 Pages (1250 words) Lab Report
sponsored ads
We use cookies to create the best experience for you. Keep on browsing if you are OK with that, or find out how to manage cookies.
Contact Us